R. Brahmankar
the tick for the cumulation and dynamic capacity check boxes for hierarchies is set up by default in the overall profile i used (using a option profile where the 2 options are checked)
also i have done a test: i have run CM01 for a WC (category 0003)
i run CM01 with an overall profile and the load is display.
the same WC belong to the hierarchy i have created with a top WC category 0004. (the WC category 0003 is Under the WC category 0004 in the hierarchy)
i run CM01 for the WC category 0004 with the same overall profile and i have checked the 2 options cumulation of Requirement and Cumulation of capacity (that i suppose you call dynamic) and the hierarchy name ad plant code in setting / general
but the load list is empty and show ZERO.
in the summary if i use the same overal profile with a WC cat 0003 and Cat 0004 (+ the 2 options Cumulation Checked) there is no results with WC cat 0004 .then i can conclude that the all the profile contain in the overall profile i used are correct..
but i don't find any reason why the load is not display in the new hierarchy.that i create
Laurent VILA